1/2" Diameter Solid Carbide Spiral Flush Trim Router Bit, 3-Flute, 1/2" Shank
Three super sharp spiral flutes ensure the cleanest possible edges when pattern cutting. The double-bearing pilot is precisely matched to the cutter diameter for a flawless match between your pattern and the finished piece. Ultra-Shear makes 1/2" 3-flute flush trim bits in cutting lengths of 1-1/2" and 2" in Up-Cut and Down-Cut versions. Use the cut length most closely matched to your material thickness and the cut-direction most appropriate for your material.
American Made Quality – Factory Direct Pricing
Up-Cut or Down Cut? In clear, relatively straight-grained solid stock, Up-Cut is usually your best choice. They clear the chips most efficiently and leave the best possible finish on the bottom edge. Down-Cut bits ensure a clean top surface, which can be an issue with veneer plywood and tricky-grained hardwoods like quilted maple and claro walnut.
Don’t settle for inferior quality imported bits to save money. Woodpeckers uses state-of-the-art CNC grinding equipment, the highest quality solid carbide blanks and ultra-fine grinding wheels to produce American-made router bits at extremely competitive prices. The days of paying extra for middle-man markups are over. Buy direct from the manufacturer and pocket the savings.
Like all Woodpeckers products, Ultra-Shear Solid Carbide Spiral bits are made right here in our Strongsville, Ohio, facility just south of Cleveland.
*NOTE: The Buy 2 or More Savings is offered when 2 or more of the same Bits are purchased.
| Country of Manufacture | United States |
|---|---|
| Flute | 3 Flute |
| Shank | 1/2" |
WARNING: Wood Dust created by Drilling, sawing, sanding or machining wood products can expose you to wood dust, a substance known to the State of California to cause cancer. Avoid inhaling wood dust or use a dust mask or other safeguards for personal protection.
