SEMBLE™ LD Parallel Jaw Clamps
Do you build furniture and smaller, delicate casework? If so, this is bound to become one of your favorite clamps. The Semble Light Duty Parallel Jaw Clamp delivers 440 pounds of clamping pressure, distributed uniformly over the jaws. That evenly applied power is delivered by a clamp that is light, nimble and easy to position.
When you're ready for better, reach for Semble.
The sliding jaw of the SEMBLE LD Parallel Jaw Clamp won’t free fall when used (or carried) vertically. Push the handle slightly toward the rail to move it toward the fixed jaw. Pull it slightly away from the rail to slide it away from the fixed jaw. In the center, it stays just where you put it. The wide footprint of both fixed and sliding jaws provide a stable base for the clamps on your bench. The 3-inch-long dual-durometer contoured handle ensures a powerful non-slip grip.
Instead of dimpling the end of the rail and making the sliding jaw a permanent fixture, SEMBLE uses a removable stop. Now you can remove the sliding jaw, reverse it, and use the clamp as a spreader. The stop does double-duty, also supporting the bar on your bench when working on your assembly. The jaws are 1-1/8” wide by 4-3/8” long with 3-1/8" throat depth. The 3/4" x 13/64" rail is zinc-coated. That means glue squeeze-out pops right off after it dries and the bar resists corrosion, even in basement shops.
Available in 6”, 12”, and 24” clamping capacity.
| Country of Manufacture | Taiwan, Province of China |
|---|