Untitled Document

Incra Jig Miter Gauge 3000 SE

incra miter 3000se

New for fall 2002, the Special Edition Incra MITER3000 SE with a 27” to 48” telescoping fence. This new miter gauge takes the top spot as Incra’s finest miter gauge tool. Now you can accurately and repeatedly set the Incra FlipSTOP anywhere along its extended 48” range without needing a 48” fence. When not extended, the heavy-duty FlipFENCE is 27” long. The last four inches then telescopes another 21”.

Like the standard MITER3000, the SE version is built around the AngleLOCK miter head with positive angle stop positions every 1/2°. This is an unprecedented level of accuracy in a miter gauge product.

The Incra MITER3000 SE features the 3/4" x 3/8” GlideLOCK steel miter bar with up to eight expandable nylon rings to achieve an absolutely perfect fit in any standard miter gauge slot.

Each MITER3000 SE comes complete with the GlideLOCK miter bar, the dual actuator AngleLOCK miter head, the new telescoping 27/48 FlipFENCE and FlipSTOP.

The new Stock-Grip Auxiliary fence both eliminates stock slippage and reduces rear-edge tear out. This 27” long, MDF sub fence is coated with a 5 mil thick non-slip plastic coating. The coating is designed to grip your work piece and keep it accurately seated during angled miter cutting. A 24” extruded aluminum T-Track is attached to the top edge, which captures a deep reach, toggle clamp. This toggle clamp easily adjusts anywhere along the fence length. Multiple clamps can be used to provide added hold down force. Replacement coated MDF fences available.

Click to download manual. (Miter3000 Manual-1.5MB)
Click to download manual. (SE Addendum Manual-1.4MB)


incra miter 3000se
The Special Edition MITER3000 SE includes Incra's finest cross cut fence, the 27/48 telescoping FlipFENCE and FlipSTOP. The unique design of the FlipFENCE guarantees a perfect stop point for mitered board ends. When in the stop position, both flip arms fully engage the fron surface of the fence, thus preventing the board tip from slipping behind the stop.

steel miter bar
The 3/4" x 3/8" steel miter bar features up to eight independent nylon expansion rings to ensure a perfect fit with the slot in your saw. A removable steel T-Clip helps to keep the miter gauge on your saw when fully retracted for wide crosscuts.

anglelock miter head
The secret to the 3000 SE’s accuracy is Incra's dual actuator AngleLOCK miter head. With positive stops every 1/2 degree, you'll be 100% confident of your miter cuts.





Incra Miter 3000SE
This Incra product may take 4-6 weeks for shipment.


Add to Wishlist


Incra Miter Express

Add to Wishlist